Lukas Novosad, Aleš Hrdlička, Pavel Slavíček, V Otruba, Viktor Kanicky

Plasma pencil as an excitation source for atomic emission spectrometry

Journal of Analytical Atomic Spectrometry 27 (2012) 305-309

A 13.56 MHz plasma jet discharge, called a plasma pencil, was investigated. Rotational and excitation temperatures, and electron number densities for the pencil under and without sample load were calculated using OH band spectra, Ar lines and H beta line, respectively. The rotational temperatures were found to be relatively low at about 800 K, however, excitation temperatures exceeded 4000 K. The plasma was found to be strongly non-isothermal. Some atomic lines of elements were easily observed. Aqueous solution-based aerosols were incorporated into the plasma without desolvation. Standard water solutions of the elements were nebulized into the plasma. The Ar carrier gas and Ar plasma gas flow rates were 0.3 and 4.0 l min(-1), respectively. The forwarded power was 140 W. Intensities of the atomic lines, temperatures and electron number densities along the discharge tube were acquired in different positions from the aerosol entrance and an optimal position providing the best signal-to-noise ratio for each line intensity was established. Calibration dependencies for Ca, Cu, Mg, Zn, Li, Na were measured in the rage of 1-100 mg l(-1). 3-sigma detection limits in the best observation axial position were (mu g l(-1)): 27 (Ca), 49 (Cu), 58 (Mg), 40 (Li), 13 (Na) and 180 (Zn).

Cited Articles

1. Klíma M., Slavíček P., Zajíčková L., Janča J., Kuzmin S., Sulovský P.,
   Plasma-Liquid Technologies for Treatment of Archaeological Artifacts,
   Czechoslovak Journal of Physics 49 (1999) 321–328
2. Janča J., Klíma M., Slavíček P., Zajíčková L.,
   HF Plasma Pencil - New Source for Plasma Surface Processing,
   Surface and Coatings Technology 116 (1999) 547–551