D. Petrovic, T. Martens, J. van Dijk, W. J. M. Brok, A. Bogaerts

Fluid modelling of an atmospheric pressure dielectric barrier discharge in cylindrical geometry

Journal of Physics D 42 (2009) 666

A numerical parameter study has been performed for a cylindrical atmospheric pressure dielectric barrier discharge (DBD) in helium with nitrogen impurities using a two-dimensional time-dependent fluid model. The calculated electric currents and gap voltages as a function of time for a given applied potential are presented, as well as the number densities of the various plasma species. This study shows that for the geometry under consideration the applied voltage parameters have a large impact on the electric current profiles and that the discharge current is always determined by the electron and ion conduction currents while the displacement current is nearly negligible. A relative broadening of the current profiles (compared with the duration of the half cycle of the applied voltage) with an increase in the applied frequency is obtained. Nearly sinusoidal current wave forms, usually typical for radio frequency DBDs, are observed while still operating at the frequencies of tens of kilohertz. For the setup under investigation, the Townsend mode of the DBD is observed in the entire range of applied voltage amplitudes and frequencies. It is shown that the average power density dissipated in the discharge increases with rising applied voltage and frequency. An increase in applied voltage frequency leads to an increase in the electron density and a decrease in electron energy, while increasing the voltage amplitude has the opposite effect.

This article may also be available to you online

Cited Articles

1. Trunec D., Navrátil Z., Sťahel P., Zajíčková L., Buršíková V.,
   Deposition of Thin Organosilicon Polymer Films in Atmospheric Pressure Glow Discharge,
   Journal of Physics D 37 (2004) 2112–2120